Mazda CX-52017 Owner's Manual page 253

Hide thumbs Also See for CX-52017:
Table of Contents

Advertisement

Do not use the Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go
function) system in the following locations, using the Mazda Radar Cruise Control with Stop &
Go function (MRCC with Stop & Go function) system at the following locations may result in
an unexpected accident:
General roads other than highways (Driving under these conditions using the Mazda Radar
Cruise Control with Stop & Go function (MRCC with Stop & Go function) system is not
possible.)
Roads with sharp curves and where vehicle traffic is heavy and there is insufficient space
between vehicles.
Roads where frequent and repetitive acceleration and deceleration occur (Driving under
these conditions using the Mazda Radar Cruise Control with Stop & Go function (MRCC with
Stop & Go function) system is not possible).
When entering and exiting interchanges, service areas, and parking areas of highways (If
you exit a highway while headway control is in use, the vehicle ahead will no longer be
tracked and your vehicle may accelerate to the set speed).
Slippery roads such as ice or snow-bound roads (Tires could spin causing you to lose vehicle
control, or the stop hold control may not operate.)
Long, descending slopes (to maintain distance between vehicles, the system automatically
and continuously applies the brakes which could result in the loss of brake power.)
Slopes with a steep gradient (The vehicle ahead may not be detected correctly, your vehicle
may slide while stopped by the stop hold control, and it may accelerate suddenly after it
starts moving.)
For safety purposes, switch the Mazda Radar Cruise Control with Stop & Go function (MRCC
with Stop & Go function) system off when it is not being used.
Do not get out of the vehicle while the stop hold control is operating:
Getting out of the vehicle while the stop hold control is operating is dangerous as the vehicle
may move unexpectedly and result in an accident. Before getting out of the vehicle, switch the
Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go function) system
off, shift the selector lever to the P position, and apply the electric parking brake (EPB).
CAUTION
If your vehicle is towed or you are towing something, switch the Mazda Radar Cruise Control
with Stop & Go function (MRCC with Stop & Go function) system off to prevent a
miss-operation.
When Driving
i-ACTIVSENSE
4-115

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents