Sony PMW-EX3 Service Manual page 53

7. Place the unit with its inside (left side) facing
toward you. Disconnect the power supply
harness from the connector (CN2) of the RE-
260 board.
8. Remove the screw. Push the CN-3022 board
and the CN-3023 board in the direction of
arrow A, and remove the EX-DD assembly
in the direction of arrow B.
9. Reinstall the removed parts by reversing
steps 5 to 8.
10. Push the extra length of the harness that is
connected to the connector (CN1) on the RE-
260 board, into a clearance between the main
frame and the EX-DD assembly.
11. Connect the coaxial cables with connector to
the two connectors (CN1) on the EC-63
board.
n
Install the coaxial cable with connector in the
way that the yellow wire faces to the bottom.
12. Reinstall each part by reversing steps 1 to 3.
PMW-EX3
EX-DD assembly
CN-3022 board
A
RE-260 board
CN1
Groove of main frame
B
M2 x 4
(Silver)
RE-260 board
CN2
EX-DD assembly
CN-3023 board
Coaxial cable
with connectors
EC-63 board
CN1
Yellow wire
Bottom side
2-27