Cn-3050 Board - Sony PMW-EX3 Service Manual

2-2-14. CN-3050 Board

1. Refer to Sections from 2-2-1 to 2-2-3, 2-2-5,
2-2-9 and 2-2-13, and disassemble the unit up
to "Inside Panel Assembly" removal.
2. Disconnect the harness from the connector
(CN1) on the CN-3050 board.
3. Remove the two screws (tapping 2 x 5) and
the screw (M2 x 4), and remove the EMC
bracket (rear top) and the CN-3050 board.
4. Reinstall the removed parts by reversing the
steps of removal.
m
. When connecting the harness to the
connector (CN1) on the CN-3050 board,
arrange the harness so that it is routed
inside the notch of the frame and inside the
hatched portion.
. When reinstalling the removed tapping
screw again, refer to note of section "2-2.
Replacement Procedures."
2-16
CN-3050 board
CN1
Frame notch
M2 x 4
(Silver)
EMC bracket
(rear top)
Tapping
2 x 5
(Black)
PMW-EX3