Canon EOS 5D Service Manual page 108

NOTE 3
⑴ Insure the lead is dressed as shown by the
arrow.
＊ If the lead is on top of the circuit board,
it will be pinched when the front cover
is installed and could cause the DC/DC
Converter to blow and the camera to
malfunction.
PV Flex
Fig. 031 Lead Dress
⑶ Insure the light shield sheet overlaps the
connector, and insure no interior parts are
visible from the outside.
Fig. 033 Light Shield Tape 2
⑵ Insure the light shield sheet does not
overlap the top cover. And insure no
interior parts are visible from the
outside.
Fig. 032 Light Shield Tape 1
13
Repair Information