Advertisement
ONE YEAR LIMITED WARANTY
Chamberlain Australia Pty Limited / Chamberlain New Zealand
(Chamberlain), warrants to the original consumer purchaser of this product
that it is free from defect in materials and/or workmanship for a period of 1
year from the date of purchase.
The benefits given to you under this Chamberlain Limited Warranty are in
addition to any rights and remedies that you may have under Australian or
New Zealand consumer protection laws. Our goods come with guarantees
that cannot be excluded under the Australian Consumer Law, or New
Zealand Consumer Guarantees Act 1993.
You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major failure.
All trade names used herein are trademarks of respective manufacturers listed.
© 2016, The Chamberlain Group, Inc. All Rights Reserved
114A4938C
Advertisement
Need help?
Do you have a question about the MC100AML and is the answer not in the manual?
Questions and answers
How to program the Chamberlain Universal Remote Control MC100AML to the Steel-Line SD800
To program the Chamberlain MC100AML Universal Remote Control to the Steel-Line SD800, follow these steps:
1. Make sure the garage door is closed and clear of obstructions.
2. On the MC100AML remote, press and hold the bottom button until the blue LED stays solid (about 15 seconds), then release it.
3. On the SD800 opener, press and hold the LEARN button for 2–3 seconds, then release it.
4. On the remote, press and release the button you want to program. The blue LED will blink for up to 60 seconds.
This completes the programming process.
This answer is automatically generated
Yes, but the On the SD800 opener has no learning button. They have a button combination like P + and - and he has stopped the problem when I follow the instructions of the SD 800 it’s not coupling
If the Chamberlain MC100AML is not coupling with the SD800 opener and there is no visible LEARN button, follow these steps to troubleshoot:
1. Check LED Indicator: Press a button on the remote. If the LED does not illuminate, replace the battery with a CR2032.
2. Locate Receiver: If the opener has no visible LEARN button, check for an external receiver with an antenna. Some receivers may require removing a cover to access the LEARN button.
3. Identify LEARN Button: The LEARN button may be labeled as CODE, CODE SET, DOOR CODE, RADIO SET, “S”, or similar. It may also be a different color than other buttons.
4. Compatibility: Ensure the SD800 opener operates on 433.92 MHz, as the MC100AML remote only supports this frequency.
If the opener lacks a LEARN button and is not compatible with 433.92 MHz, the MC100AML may not work with it.
This answer is automatically generated
Yes they have the same 433.93 and I checked no external receiver. But I can send a pic of the 800