Advertisement
PROGRAMMING THE REMOTE
These are generic instructions for most garage door openers, however you
may need to refer to the instructions for your opener if your remote does
not program.
Note: Please read through all steps before programming the remote.
For ATA branded openers, please refer to the instructions on page 5.
1
Start with your garage door closed. Ensure that the door is clear of all
obstructions.
2
Press and hold the bottom button on
the remote control until the blue LED
on the remote stays solid (approximately
15 seconds), then release the button.
3
Press and hold the LEARN button on your garage door opener for 2-3
seconds before releasing it (refer to the diagram on page 4 for
where the LEARN button may be located).
On the remote control, press and release the remote button you would
like to program. The blue LED will blink for up to 60 seconds. Once the
LED changes to solid blue press and release the button on the remote
that you are programming.
4
The remote will begin flashing once every three seconds. Once the door
begins moving press the remote button again. Your remote is now
programmed to the garage door opener.
You can repeat this process using the other remote button to program
another garage door opener.
TEST
Test the remote control by pressing the button you programmed to control
the door. If the garage door opener does not activate, repeat the
programming steps or visit chamberlaindiy.com.au/universal or
chamberlaindiy.co.nz/universal for additional instructions.
3
LED
Bottom
Button
Advertisement
Need help?
Do you have a question about the MC100AML and is the answer not in the manual?
Questions and answers
How to program the Chamberlain Universal Remote Control MC100AML to the Steel-Line SD800
To program the Chamberlain MC100AML Universal Remote Control to the Steel-Line SD800, follow these steps:
1. Make sure the garage door is closed and clear of obstructions.
2. On the MC100AML remote, press and hold the bottom button until the blue LED stays solid (about 15 seconds), then release it.
3. On the SD800 opener, press and hold the LEARN button for 2–3 seconds, then release it.
4. On the remote, press and release the button you want to program. The blue LED will blink for up to 60 seconds.
This completes the programming process.
This answer is automatically generated
Yes, but the On the SD800 opener has no learning button. They have a button combination like P + and - and he has stopped the problem when I follow the instructions of the SD 800 it’s not coupling
If the Chamberlain MC100AML is not coupling with the SD800 opener and there is no visible LEARN button, follow these steps to troubleshoot:
1. Check LED Indicator: Press a button on the remote. If the LED does not illuminate, replace the battery with a CR2032.
2. Locate Receiver: If the opener has no visible LEARN button, check for an external receiver with an antenna. Some receivers may require removing a cover to access the LEARN button.
3. Identify LEARN Button: The LEARN button may be labeled as CODE, CODE SET, DOOR CODE, RADIO SET, “S”, or similar. It may also be a different color than other buttons.
4. Compatibility: Ensure the SD800 opener operates on 433.92 MHz, as the MC100AML remote only supports this frequency.
If the opener lacks a LEARN button and is not compatible with 433.92 MHz, the MC100AML may not work with it.
This answer is automatically generated
Yes they have the same 433.93 and I checked no external receiver. But I can send a pic of the 800