Service Door - Saeco XELSIS SM7581 User Manual

English
16
you are unable to solve the problem, contact the Consumer Care Center in your country. For contact
details, see the warranty leaflet.
Problem
The drip tray fills up
quickly.
The machine is in DEMO
mode.
The 'coffee grounds
container full' icon
remains displayed.
I cannot remove the
brew group.
I cannot insert the brew
group.
The coffee is watery.
Cause
This is normal. The machine
uses water to rinse the internal
circuit and brew group. Some
water flows through the internal
system directly into the drip
tray.
You pressed the standby
button for more than 8
seconds.
You emptied the coffee
grounds container while the
machine was switched off.
You placed back the coffee
grounds container too fast.
The brew group is not in the
correct position.
You have not removed the
coffee grounds container.
The brew group is not in the
correct position.
The machine is still in the
descaling procedure.
The grinder is set to a too
coarse setting.
The coffee exit duct is clogged.
Solution
Empty the drip tray when the 'drip tray
full' indicator pops up through the drip
tray cover (Fig. 24). Place a cup under
the dispensing spout to collect rinsing
water.
Switch the machine off and then on
again with the main switch on the back
of the machine.
Always empty the coffee grounds
container while the machine is switched
on. If you empty the coffee grounds
container when the machine is switched
off, the coffee cycle counter is not reset.
Do not place back the coffee grounds
container until the screen prompts you
to put it back.
Reset the machine in the following way:
place back the drip tray and the coffee
grounds container. Then close the
service door and switch the machine off
and back on again. Try again to remove
the brew group.
Remove the coffee grounds container
before you remove the brew group.
Reset the machine in the following way:
place back the drip tray and the coffee
grounds container. Leave the brew
group out. Close the service door and
switch the machine on and off. Then put
the brew group in the correct position
(see 'Reinserting the brew group') and
reinsert it into in the machine.
You cannot remove the brew group
when the descaling procedure is in
progress. First complete the descaling
procedure and then remove the brew
group.
Set the grinder to a finer (lower) setting.
Clean the coffee exit duct with the
spoon handle. Then switch the machine
off and on again.