Panasonic AW-HR140EJ Operating Instructions Manual page 105

Displaying the web screen using a mobile terminal (continued)
Camera menu (OSD menu) operation
When this button is pressed, the buttons for performing the camera
menu operations are displayed on the screen.
At the same time, the camera menus are displayed on the unit's
images.
The unit's camera menu operations can be performed by
pressing the ,
When any of these buttons is pressed to switch to an
operation that does not involve a camera menu, the camera
menus are no longer displayed on the unit's images.
For details of the camera menu, refer to page 54.
Tally lamp lighting status displays
The status of the tally signal of the connected camera is checked at
regular intervals and the display is updated.
When the camera receives a tally signal, the IP video display area
frame turns red.
The original display is redisplayed when the receiving of the tally
signal is canceled.
<NOTE>
• It may take 2 seconds or so for a change in the status of the tally
signal to be reflected on the display of the mobile terminal.
, and buttons.
<NOTE>
• If the HTTP port number has been changed from "80", enter "http://<IP
address>:<port number>/mobile/"
• When [HTTPS] - [Connection] (→ page 91) is set to [HTTPS] in
the [Advanced] tab of the Network setup screen [Network], enter the
following.
https://<IP address port number>/mobile
• When the authentication dialog box appears, enter the user name and
password of an administrator or general user.
Depending on the mobile terminal, password entry may be required
when transitioning between each screen.
• Audio cannot be received on mobile terminals.
• If the [User auth.] (→ page 84) setting has been changed to
[On] from a personal computer while the mobile terminal screen is
displayed, it may not be possible to refresh the mobile terminal screen.
In a case like this, first close the web browser which is running on the
mobile terminal, and then open the mobile terminal screen again.
• If the images are large, it may not be possible to display them on
some mobile terminals. In such cases, displaying the images may be
possible if a value closer to the lowest image quality is selected for
[Image quality] (→ page 68) in [JPEG].
• Access may not be possible depending on your mobile terminal and
device plans.
• If, when using an Android terminal, more than one button is pressed
at the same time, one of the buttons may remain pressed even after it
has been released. At a time like this, press again only that button that
has remained pressed to release it.
Example) When the pan (left) button and pan (right) button are
pressed at the same time, either the pan (left) button or
pan (right) button will remain pressed, and panning will
continue.
→ When the pan (left) button or pan (right) button that has
remained pressed is pressed again, the panning will
stop.
* 1
This IP address is the global IP address for the WAN of the router
that enables internet access.
However, it is the local IP address if the unit in the same LAN is
to be accessed using a mobile terminal which supports a wireless
connection.
105
1 to specify the unit's port number.
*