Port Number(Http); Port Number(Https) - Panasonic AW-HR140EJ Operating Instructions Manual

Web screen configurations (continued)
z Updating the firmware
z
Perform the following to update the firmware.
1.
After consulting with your dealer, download the latest
software to the hard disk of your personal computer.
<NOTE>
• No spaces or full-size characters can be used for the directory in
which the software will be stored.
• Keep the maximum combined number of characters to be used for
the name of the directory in which the software will be stored and for
the name of the software which has been downloaded to less than
250 characters.
2.
Click the [Browse] button, and specify the downloaded
software.
3.
Click the [Execute] button.
The software upgrade check screen is displayed.
After upgrading the software version, be absolutely sure to delete the
temporary Internet files.
<NOTE>
• Be absolutely sure to upgrade the software versions from the
personal computer in the same network (LAN) as the unit whose
firmware version is to be updated.
<NOTE>
• After the [Execute] button is pressed, the amount of time it takes for
the version upgrade progress bar to appear is about 1 minute for
the AVIO FPGA or about 2 minutes for the Network software. The
progress bar wil appear within 1 minute for other firmware.
• Use the personal computer on the same subnet as the camera to
upgrade the software version.
• Before using the version upgrading software, be absolutely sure to
check the precautions to be observed with your dealer, and follow the
dealer's instructions.
• Use the following files specified by Panasonic Corporation as the
software used for version upgrading.
CPU Software Interface .sif files
CPU Software Camera
.scm files
Main
CPU Software Servo .spt files
CPU Software Network .snw files
EEPROM Interface .eep files
FPGA Lens .fls files
FPGA AVIO .fav files
FPGA Com .fco files
• Do not turn off the unit's power while upgrading a software version.
(Do not turn off the power until the progress bar display is cleared.)
• While a software version is being upgraded, do not attempt to execute
any other operations until the version has been upgraded.
Status confirmation screen [Status]
„ z
Confirm the status of the unit.
z UPnP
z

Port number(HTTP)

Displays the port number configured via UPnP port forwarding.
Status
Displays the port forwarding status.

Port number(HTTPS)

Displays the port number configured via UPnP port forwarding.
Status
Displays the port forwarding status.
Router global address
Displays the global address of the router.
100