Table of Contents
Advertisement
0001
Bad packet
0002
Out of sequence
0003
Not Ready for new
commands
0004
Incorrect command
format
0005
Command invalid
for coordinators
0006
Command invalid
for endpoints
0007
Add endpoint failed The host attempted to add an endpoint but the process
0008
Remove endpoint
failed
0009
Not ASCII coded
hex
000a
Command not
recognized
000b
Key received, no
provisioning
000c
Discover endpoints
timeout
000d
Unencrypted
packet
000e
Supervisory not
received
C
© 2017, R
OPYRIGHT
ADIO
Received a packet over the radio that cannot be
understood or interpreted properly. May indicate a
device is not compliant with the SubGig standard
Received a packet over the radio that was out of
sequence. See the SubGig spec for more detail. The
counters are reset at power on and are not saved in non-
volatile memory.
The host is attempting to send new commands but the
device is not ready to receive new commands yet.
The format of the serial command sent to the device is
wrong.
A command was sent to a coordinator that is invalid for
coordinators.
A command was sent to an endpoint that is invalid for
endpoints
failed. Likely due to maximum endpoints exceeded.
The host attempted to remove an endpoint but the
process failed. Likely due to endpoint not in the list.
The values provided were not ASCII coded hex values.
A command was sent to the device that was not
recognized
An endpoint received a key that was broadcast from a
coordinator but no provisioning key has been set yet. Key
is rejected.
The discover endpoint process for a coordinator timed
out with no endpoints found.
Received an unencrypted packet while encryption was
enabled.
Message from a coordinator indicating that a supervisory
message was not received from an endpoint.
B
I
.
RIDGE
NC
R
B
ADIO
RIDGE
R
B
RBM101 U
ADIO
RIDGE
RBM101 U
G
SER
UIDE
G
P
22
35
SER
UIDE
AGE
OF
Advertisement
Table of Contents
