Table of Contents
Advertisement
4.3.1.7 VI – Vendor ID
Set 32-bit optional Vendor ID for the module. This is set to 0 at the factory and should be set
to the 32-bit vendor ID assigned by the SubGig Alliance. The purpose of the Vendor ID is to
define industry-specific user payloads to allow for interoperability within an industry. The
Vendor ID is optional and does not need to be set for normal operation.
The parameters are ASCII coded hex characters. For example, a Vendor ID of 0x12345678
would be represented by the string "12345678". If no parameters are provided in the
command, the Vendor ID is returned.
4.3.1.8 Enter Bootloader
This command will stop normal program execution and jump to the bootloader. A new menu
will appear with the same serial port settings that will allow the user to load a new signed and
encrypted firmware image through the XMODEM protocol. From the bootloader there will be
a menu option to run the new firmware image and jump back to normal program execution.
It is recommended to use the Radio Bridge configuration app for firmware updates.
4.3.1.9 BT – Bootloader Timeout
This command changes the time that the bootloader waits for the <DEL> character prior to
booting the application. The parameter is a 4 digit ASCII coded hex value and is in units of
milliseconds:
Default: 0BB8 for 3 seconds
Range: 0000 to 0BB8
If the range is set to 0, the bootloader will automatically run the application at reset and the
only way to enter the bootloader is to drive the BTL pin to ground. See the Bootloader section
for more detail.
4.3.1.10
AE – Add Endpoint
Command to coordinator to manually add an endpoint to the list of connected devices. The
parameter after AE is the 32-bit Device ID of the endpoint represented as ASCII coded hex
characters. For example, a Device ID of 0x12345678 would be represented by the string
"12345678".
Note that each system is limited to 255 endpoints and this command will return with an error
if that number is exceeded.
4.3.1.11
DE – Discover Endpoint
Command to coordinator to find the next ID sent over the wireless link and automatically add
it to the list of connected endpoints. This command should be followed by a broadcast ID (BI)
command or a sensor event transmission from an endpoint.
C
© 2017, R
OPYRIGHT
ADIO
B
I
.
RIDGE
NC
R
B
ADIO
RIDGE
R
B
RBM101 U
ADIO
RIDGE
RBM101 U
G
SER
UIDE
G
P
12
35
SER
UIDE
AGE
OF
Advertisement
Table of Contents
