Table of Contents
Advertisement
4.3.1.34
RP – Reduce Power Level
Set the radio transmit power to a reduced level based on governor requirements. The
parameter value can be one of the following:
"0": Reduced power mode off
"1": Reduced power mode on
Default is off. When the command is used to turn the reduced power mode on, the transmit
power level is reduced to the level acceptable for periodic signals according to FCC
requirements. See the section on Governor for more detail.
4.3.1.35
TC – Test carrier
This command will cause the module to enter a debug mode where it transmits a constant
carrier signal at the center frequency of the module. The parameter value can be one of the
following:
"0": Test carrier disabled
"1": Test carrier enabled
Test carrier is disabled by default.
4.3.1.36
TP – Test packets
This command will cause the module to enter a debug mode where it transmits constant
packets over RF. The parameter value can be one of the following:
"0": Test packets disabled
"1": Test packets enabled
Test packets is disabled by default.
4.3.1.37
SN – Sniffer Mode
This command will cause the module to enter a debug mode where it "sniffs" all packets in
the air utilizing the SubGig protocol and display them with the "SNF" prefix. This "sniffing"
continues until the mode is disabled. The parameter value can be one of the following:
"0": Sniffer disabled
"1": Sniffer enabled
The sniffer is disabled by default. See the
C
© 2017, R
OPYRIGHT
ADIO
B
I
.
RIDGE
NC
R
B
ADIO
Sniffer Mode
section for more detail.
R
B
RBM101 U
ADIO
RIDGE
RBM101 U
G
RIDGE
SER
UIDE
G
P
19
SER
UIDE
AGE
OF
35
Advertisement
Table of Contents
