5. M
ESSAGES
5.1. Status Messages
This section defines status messages that are sent from the module back to the host over the
serial port.
The status message begins with the ASCII characters "STA " and is followed by a Device ID if
relevant as defined in the
following table.
Code
Status
0000
Device reset
0001
Sleepy supervisory
received
0002
Queued message
sent to sleepy
endpoint
0003
Supervisory now
current
5.2. Error Messages
This section defines the error messages that are sent from the module back to the host over
the serial port. The message begins with the ASCII characters "ERR" as defined in the
Commands
Code
Error
0000
No ack
C
© 2017, R
OPYRIGHT
ADIO
Note that status messages do not include errors. Error messages are defined
in the section
Error
Messages.
Serial Commands
Table 10 Status Messages
Description
Device just came out of reset
A supervisory message from a sleepy endpoint just
arrived. The host has a period of time defined by the
Listen Window to send messages to the endpoint before
it re-enters sleep mode.
The message we queued for the sleepy endpoint has
been sent in the listen window.
Coordinator received a supervisory message from an
endpoint that was not previously reporting
section. This error codes are defined in the following table:
Table 11 Error Messages
Description
No ack has been received after transmitting data after
retries have been exhausted.
B
I
.
RIDGE
NC
R
B
ADIO
RIDGE
section. These error codes are defined in the
R
B
RBM101 U
ADIO
RIDGE
RBM101 U
G
SER
UIDE
Serial
G
P
21
35
SER
UIDE
AGE
OF