Snf": Sniffer; App": Application Payload; At Command Reference; At Commands - Radio Bridge RBM101 User Manual

Some status messages have an associated Device ID, and if this is the case then the status
code would be followed by the Device ID. For example the status message for a sleepy
supervisory message for Device ID 12345678 would be:
STA 0001 12345678

4.2.4. "SNF": Sniffer

When the device is put into sniffer mode using the SN AT command, the device will report all
packets it sees broadcast on the SubGig protocol. All of these packets that have been "sniffed"
from the air are displayed with this prefix. See the

4.2.5. "APP": Application Payload

Wireless user payload data received from a remote module. If the device is configured as an
endpoint then this would be user payload data from the coordinator, and if the device is
configured as a coordinator then this would be user payload data from an endpoint.
If a device is a coordinator and receiving data from an endpoint, then the first 32-bits (8 ASCII
coded hex characters) of this message will be the Device ID of the data source.

4.3. AT Command Reference

This section defines the serial AT commands that can be sent to the module.

4.3.1. AT Commands

All AT commands begin with an ASCII "AT", followed by a two ASCII character command, and
followed by optional parameters depending on the command. The prefix "AT" can be used
standalone to determine if a device is available, out of reset, boot-loading complete and
responding. Upon sending "AT" with no additional command or payload, the device should
respond "CMD OK" if it is alive. This command may be used during a system boot-loading
process where a bootloader delay is used to determine if the device is ready.

4.3.1.1 SP - Send Packet

This is the basic command during normal operation to send a data payload from one module
to another. This command is used by both the coordinator sending data to an endpoint and
by an endpoint sending data to the coordinator.
C © 2017, R
OPYRIGHT ADIO
Note that status messages do not include errors. For errors see the message
type Error Message. See the
B I .
RIDGE NC
R B
ADIO RIDGE
Status Messages section for more detail.
Sniffer Mode section for more detail.
R B RBM101 U
ADIO RIDGE
RBM101 U G
SER UIDE
G P 10 35
SER UIDE AGE OF