Download Print this page

Orbit Research Orbit Reader 20 User Manual page 49

Hide thumbs Also See for Orbit Reader 20:

Advertisement

Error message: The application has failed to start because its side-by-side
configuration is incorrect. Please see the application event log or use the
command-line sxstrace.exe tool for more detail.
If Orbit Reader does not come on or seems to freeze, use these steps:
1. Plug in power to ensure the battery is charged. Use the supplied AC
wall connector and cable to obtain the most reliable power source. Let
the unit charge for at least a few hours.
2. Hold the Power Button for at least two seconds. If the unit is on, it
should turn off. If it is off, it should come on.
3. Remove the SD card, then hold the Power button for two seconds. If
the card was the cause of the problem, the unit should come on.
4. Unplug Power, then hold the Power Button for at least two seconds.
5. Hold the Power Button for at least 10 seconds.
6. Press the Reset command (press Space + dot 5 + Right Panning key).
Try the Power button again.
7. Finally, remove the battery. Leave it out for a few minutes, reconnect
it, then try the steps again.
Battery Use and Replacement
Orbit Reader includes a rechargeable Lithium-ion 2200mAh capacity battery.
It fully charges in about three hours under optimal conditions. When you
plug in the cable, "Battery plugged in" is briefly displayed. Once charged,
"Battery charged" is displayed. A full battery charge lasts approximately
three days of typical use. Check the battery level in the menu.
The battery in Orbit Reader should last several years. Gradually, the battery
begins holding its charge for less and less time. When the amount of time
the battery holds a charge becomes inconvenient, it is time for replacement.
To replace the battery, follow these steps:
1. Obtain a replacement battery. Use only the battery designed for Orbit
Reader 20.
2. Remove the battery door screws.
3. Remove the battery door.
4. Carefully unplug the connector. Do not pull on the wire. Use the
connector instead.
5. Insert the new battery.
6. Replace the cover and screws.
Accessories Information

Advertisement

loading
Need help?

Need help?

Do you have a question about the Orbit Reader 20 and is the answer not in the manual?

Related Products for Orbit Research Orbit Reader 20