Orbit Research Orbit Reader 20 User Manual page 28

Long
Go to top or
press Up
end of
or Down
document
Arrow
Editor Block Text Commands
The Editor block operations depend on a selection. The selection is the text
between the cursor and the mark.
To ... Press
Set or
Select,
clear
M
Mark
Select,
Copy
C
Select,
Paste
V
Select,
Cut
X
Remote Device Operational Mode
In addition to using Orbit Reader as a portable reading tool and editor, it
connects with host devices (i.e., computers, phones, and tablets) to provide
braille input and output to that device. The host device must be running
software that supports braille.
- For Windows PCs - JAWS®, Window-Eyes, System Access, and NVDA
- For Mac® computers and iOS® devices - VoiceOver
- For Android devices - BrailleBack and TalkBack
Long pressing Up or Down Arrow moves the
cursor to the top or bottom of the document.
Here's why and/or additional information
The editor indicates a mark by raising both dots 7 and 8
on the character where the mark occurs. To set or clear a
mark in the file, press the Mark command. If there was
already a mark at the cursor, the editor shows "Mark
cleared" on the display and removes the mark. If there
was not a mark, it shows "Mark set" and adds a mark.
The copy command places the selected text onto the
clipboard for later use in this or another file.
To paste the contents of the clipboard before the cursor,
use the Paste command.
To remove the selected text from the document and place
it onto the clipboard, use the Cut command. If you want
to put that text somewhere else, move to the desired
position, then use the Paste command.