Removing The Dvd Mechanism Assembly - JVC FS-Y1 Service Manual

3.1.12 Removing the DVD mechanism assembly

(See Figs.25 to 28)
• Remove the side panels L/R, top panel assembly, tuner, rear
panel, switching power supply, digital amplifier board assem-
bly, micom board and regulator board.
(1) From the right side of the main body, remove the screw V
attaching the metal chassis. (See Fig.25.)
(2) From the top side of the main body, remove the two screws
W and take out the metal chassis. (See Fig.26.)
Reference:
When attaching the metal chassis, pass the card wire
through the hole t on the metal chassis as before.
(3) Disconnect the card wire from the connector
video board. (See Fig.27.)
(4) Remove the screw X and take out the DVD mechanism as-
sembly from the bottom chassis. (See Fig.27.)
Reference:
When the resolution of DVD mechanism assembly is done se-
quentially, remove a CD fitting in the direction of the arrow.
(See Fig.28.)
Metal chassis
V
Metal chassis
t
CN703
Fig.25
W
W
Fig.26
DVD mechanism assembly
on the
CD fitting
Video board
X
CN703
Bottom chassis
Fig.27
DVD mechanism assembly
Fig.28
(No.MB376)1-15