Cook's essentials CEPC660 Owner's Manual page 8

CONTROL PANEL OPTIONS
Once pressure is reached, the unit will begin to count down in
minutes and will beep 3 times when the cooking time has elapsed.
The Pressure Cooker will beep periodically as a reminder that your
cooking is completed. To cancel this, press and hold the
START/STOP Button until it beeps. Let the pressure drop on its
own by using the Natural Steam Release Feature, or release
pressure immediately by pressing the QUICK STEAM RELEASE
Button in short bursts until pressure is reduced.
WARNING: DO NOT hold the QUICK STEAM RELEASE Button
down, as hot liquids may be ejected. Press in short bursts until
pressure is reduced.
NOTE: To cancel or stop cooking before time has elapsed, press and
hold the START/STOP Button until the red STOP Light illuminates
and the Pressure Cooker beeps.
4. COOK TIME: Use this Timer when using the COOK MODE
(STEAM) or the PRESSURE MODE (HIGH or LOW) settings. Press
COOK TIME Button to set the desired cooking time.
5. DELAY TIME: Allows you to begin cooking food up to 2 hours later
in 1/2 hour increments.
6. START/STOP: After choosing the desired MODEs: KEEP WARM,
COOK MODE: (BROWN or STEAM), or PRESSURE MODE: (HIGH
or LOW), and if appropriate, the COOK TIME, press the
START/STOP Button to begin operating the appliance. The green
START Indicator Light will be lit when START is chosen. The red
Indicator Light will illuminate for STOP. If you wish to change your
selection, or to stop the appliance, press and hold START/STOP
until the red STOP Indicator Light illuminates and the Pressure
Cooker beeps.
This Pressure Cooker has an Idle MODE. If you input a COOK TIME
and/or DELAY TIME, but forget to select a program or if you forget to
press START, the Clock will display "--" after 5 seconds. This Feature is
for your convenience to show that the program is incomplete. The "--"
signal indicates that the Pressure Cooker is not programmed properly
and will not run. You can proceed with the program where you left off
by pressing the COOK TIME or DELAY TIME Button. Your selected
time will reappear. If this time does not appear, or if it is incorrect,
simply enter the correct time and then press the START/STOP Button.
(Continued)
7