Allocating Channel Numbers To Specified Frequencies - Park Air T6T User Manual

ALLOCATING CHANNEL NUMBERS TO SPECIFIED FREQUENCIES

Up to 100 frequency channels can be stored in the transmitter. Use the following procedure to allocate
frequency channels.
The process of allocating frequency channels can be simplified by using the VFP.
The VFP software is contained in the T6T transmitter's maintenance kit.
1. From the Main screen, press the switch to
display the Options menu. Turn the switch
until Channel is highlighted. Press the
switch.
2. Ensure the Channel menu is displayed. Turn
the switch until Set is highlighted. Press the
switch.
3. Ensure the Channel screen is displayed and
turn the switch until the channel number is
highlighted. Press the switch, then turn the
switch until the required channel number is
displayed. When it is, press the switch.
4. Turn the switch to highlight the MHz value, then press the switch. Turn the switch until the
required value is displayed, then press the switch. Repeat for the kHz value.
5. When the correct
displayed channel number is displayed, turn
the switch until Store is highlighted, then
press the switch.
6. Repeat steps 3 to 5 for all frequency channels that are to be stored. When the required number of
frequency channels have been stored, highlight Store and End and press the switch. You will be
returned to the Main screen.
T6T AM-Voice Operation
frequency for the
F r e q u e n c y
C h a n n e l
C o n f i g u r e
B I T
C h 0 0 7 1 2 3 . 4 5 0 M H z
R e c a l l
S e t
B a c k
C h 0 0 1 1 1 9 . 1 0 0 M H z
R e c a l l
S t o r e
S t o r e a n d
C h 0 0 1 1 1 9 . 1 0 0 M H z
R e c a l l
S t o r e
S t o r e a n d
E x i t
E n d
E n d
Section 2
Page 35