Dc Supply Connection; Connecting An Antenna; Switching On - Park Air T6T User Manual

DC SUPPLY CONNECTION

The transmitter operates from either an ac, or a dc input supply. When both ac and dc are connected,
operation from the ac supply takes priority; automatic change-over to the dc supply occurs if the ac
supply fails. On restoration of the ac supply, the equipment reverts to ac operation.
A dc input supply connector (see Fig. 1-5 on page 15) is fitted to the equipment's rear panel. The
2
recommended minimum rating of the dc supply cable is: 2-core having a cross-sectional area of 1.5 mm
per core. The supply cable should be fitted with an XLR3 connector (PAE part number 20-01030106).

CONNECTING AN ANTENNA

The antenna feeder cable connects to the transmitter's rear panel N-type antenna connector (see
Fig. 1-3 on page 14).

SWITCHING ON

When installation is complete, the transmitter should be switched on at the rear panel Power switch (see
page 14).
T6T General Information Section 1
Page 27