Fitting A Radio Into An Equipment Rack; Connecting Remote Facilities - Park Air T6T User Manual

Table of Contents

Advertisement

FITTING A RADIO INTO AN EQUIPMENT RACK

CAUTION!
It is essential that the chosen mechanical installation provides adequate support along
the depth (front to rear) of the unit. The transmitter must not be supported by the front
panel; doing so can cause damage.
The transmitter can be installed on telescopic slides, or on fixed runners, within a standard 483 mm
(19 inch) equipment rack. M4 tapped holes, each 10 mm deep (see Fig. 1-11) are provided on each side
of the equipment to accept the slides. Details of suitable telescopic slides and fixed runners are available
from PAE.
When fitted in the rack, the transmitter's front panel must be secured to the racks chassis using four
M6 x 16 mm screws and plastic washers.
(DEV083-09)

CONNECTING REMOTE FACILITIES

Remote facilities connections depend on the transmitter's operating mode. To determine the required
remote connections, refer to chapter 3 of the section applicable to the operating mode.
T6T General Information
Fig. 1-11. Telescopic Slide Fixing Points
Section 1
Page 25

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Park Air T6T

Table of Contents