Operational Settings; Basic Configuration; Local Operation - Park Air T6T User Manual

OPERATIONAL SETTINGS

Operational settings for the T6T transmitter are configured at the front panel, through the VFP, or
through an associated MARC system (or compatible control and data system). At the transmitter,
operational settings are selected and displayed using the front panel Scroll/Select switch and the LCD.
The settings that can be selected are:
q
Operating frequency
q Selecting the channel spacing
q
Setting the line level
q
Standby mode to on or off
q
Setting the MARC baud rate
q
Setting the PTT output signal polarity
q Setting the BIT initiate signal polarity
q
Setting the antenna change-over signal
polarity
q
Setting the PTT timeout
q Mute enable or disable
q
Adjusting the sidetone volume

BASIC CONFIGURATION

Fig. 2-1 shows the basic T6T transmitter connections for AM voice operation. If the transmitter is part of a
MARC system, or other compatible control and data system, refer to 'Configuration for Operation with
MARC' on page 6.

Local Operation

In its simplest configuration, the transmitter can be operated in Local mode. This involves plugging a
microphone with integral PTT switch into the front panel Microphone/Diagnostics connector. The
transmitter is then operated from the front panel.
Section 2
Page 4
q
Selecting a carrier offset
q Channel allocation and recall
q
Setting the output power
q
Setting inhibit to on or off
q
Setting the PTT input signal polarity
q
Setting the inhibit input signal polarity
q Setting the Ready output signal polarity
q
PTT test facility
q
Setting the modulation depth
q Vogad enable or disable
q
Setting the LCD backlight
T6T AM-Voice Operation