Fluke OptiFiber PRO OTDR Getting Started Manual page 6





2-4 To save the settings, tap SAVE on the TEST SETUP screen.
A
B
C
To set up a project, tap the PROJECT panel.

 To change settings for the test or select a different test, tap
the test setup panel.
To set up cable IDs, turn on Auto Save, and change the

settings for the fiber End, tap the Next ID panel.
To upload test results to LinkWare Live, tap SYNC.

Networks products at:
Launch Compensation: If you will use launch/tail cords set
this to On.
Wavelength: Select the wavelengths for the test.
Fiber Type: On the FIBER TYPE screen, select a fiber type
that is applicable. To see a different group of fiber types,
tap MORE, then tap a group.
Test Limit: Select the correct test limit for the job. To see a
different group of limits, tap MORE, then tap the name of
a group.
Figure 2. Panels on the Home Screen
ShopFlukeNetworks
D
GSM01.EPS
1.800.561.8
.ca