Table of Contents
Advertisement
7. INSTALLATION
1.
2.
3.
4.
5.
6.
7.
8.
9.
At the
time of mounting the printer mechanism into its housing cabinet, put cushion material,
such as, rubber foot, on the printer mechanism legs. If installed directly, reverberations
occur
producing noise. We recommend
that you use the following rubber foot.
010
Parts name : DAMPER RUBBER SP2
Parts No.
: 30290010
Fig. 7-1 Recommended Rubber foot
Spacer
L.1
04 2/5
Parts
name
Parts
No.
Unit: mm
Fig.
7-2
Recommended Set screw
: SCREW 3.0
: 30250010
Set
the play between the roll paper holder and paper thrust direction to within 2mm, and ensure
that the roll paper holder doesn't hold back the edge of paper.
Set the paper inserting angle to within 40°.
Attach R of size R2 or larger at places which contact the corners of the paper insertion case.
Set the paper feed load, at the printer's paper inlet, to 30g or less.
Take into account prevention of paper rewinding, when designing the case.
Allow needed space surrounding the printer. Fig. 7-3 shows an example of installation space.
In the case of MP216, please be especially careful as the ribbon moves up and down.
Fig. 7-4 shows an example of installation.
Since this printer mechanism employs galvanized steel panels, the end surface doesn't come
plated.
-29-
Advertisement
Table of Contents
