Addressing; Program Starting Address; Program Starting Address Without Calibrating - Philips VARILITE VL1100 LED User Manual

Addressing

Program Starting Address

The DMX starting address is entered using the Menu Display. This address will be retained even if the
power is removed.
Note: Refer to
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.
To program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Address appears. Press [Enter].
Step 3. DMX will appear. Press [Enter].
Step 4. Press [Up] / [Down] arrows to enter starting address.
Step 5. Press [Enter] to set.

Program Starting Address Without Calibrating

It is possible to bypass the calibration sequence and go directly to the Menu Display programming in
order to pre-program an address setting.
To program starting address without calibrating luminaire:
• While powering up luminaire, press and hold [Menu]. Program address as in
Address
• Release when display reads ":"
Note: The luminaire will require a reset to restore control.
02.16 02.000 2
Chapter 4: "Menu System" on page 51
above.
for detailed instructions on menu functions.
13 J un e 20 17
I : A
NSTALLATION DDRESSING
Program Starting
2
23