Philips VARILITE VL1100 LED User Manual page 31

DMX Termination Connector
A male XLR DMX termination connector is required at the last luminaire
(or "far end of the line") to prevent signal reflections. Signal reflections
may cancel out the signal at certain line lengths, resulting in errors. The
terminator is also necessary for software downloads and running tests on
multiple luminaires. To construct your own connector, you will need the
following components:
• 5-pin, male XLR connector.
• Two 1/4W 5% 120 ohm resistors.
Note: A male termination connector is available as an accessory from Philips. See
page 10.
Loopback Connector
When transferring software versions from luminaire to luminaire, a
loopback connector is required at the first luminaire in the data link.
To construct your own connector, you will need the following
components:
• 5-pin, female XLR connector.
• Two small segments of 22 AWG wire.
Note: A loopback connector is available as an accessory from Philips Entertainment Lighting. See
"Accessories" on page
02.16 02.000 2
I : P
NSTALLATION
10.
13 J un e 20 17
D C
OWER AND ATA ABLING
2
R
EQUIREMENTS
1 5
2 4
3
Solder resistors across
pins 2 & 3, and 4 & 5
"Accessories" on
5 1
4
2
3
Solder wires across
pins 2 & 4, and 3 & 5
15