Addressing; Program Starting Address; Program Starting Address Without Calibrating Luminaire - Philips VARI LITE VLZ SPOT Luminaire User Manual

Moving spot luminaire

Table of Contents

VARI LITE VLZ SPOT Luminaire User's Manual

Addressing

The address setting for DMX console controlled systems is entered using the Menu Display

(refer to

"Menu Operation" on page

power is removed.

Note: Refer to your console operating instructions for specific information regarding its

addressing requirements.

Program a DMX starting address:

Step 1. Make sure unit is powered and turned on.

Step 2. Press [MODE/ESC] to access menu categories.

Step 3. Use four Arrow (

and settings.

Step 4. Once menu item is reached, press OK

Step 5. Make changes to parameters as desired.

Step 6. Press

It is possible to bypass the calibration sequence and go directly to the Menu Display

programming in order to pre-program an address setting.

Program starting address without calibrating luminaire:

While powering up luminaire, press and hold [MODE/ESC]. Program address as in

Program Starting Address above.

Press and hold [MODE/ESC] until display changes to the DMX address.

Note: The luminaire will require a reset to restore control. See "VLZ SPOT Control

Channel Functions"

45). The luminaire retains the DMX address even if

button to accept changes.

chapter on page 29

) buttons to navigate through the various options

to access the menu item parameters.

for control channel information on luminaire reset.

Table of Contents