Step
Apply a policy locally.
2.
Configuring interface PBR
Configure PBR by applying a policy to an interface. PBR uses the policy to guide the forwarding of
packets received on the interface. The specified policy must already exist. Otherwise, the interface
PBR configuration fails.
You can apply only one policy to an interface. Before you apply a new policy, you must first remove
the current policy from the interface.
You can apply a policy to multiple interfaces.
To configure interface PBR:
Step
Enter system
1.
view.
Enter interface
2.
view.
Apply a policy
3.
to the interface.
Displaying and maintaining PBR
Execute display commands in any view and reset commands in user view.
Task
Display PBR policy information.
Display PBR configuration.
Display local PBR configuration and statistics.
Display interface PBR configuration and
statistics.
Clear PBR statistics.
PBR configuration examples
Packet type-based local PBR configuration example
Network requirements
As shown in
Switch A forwards other packets according to the routing table.
Command
system-view
interface interface-type interface-number
ip policy-based-route policy-name
Figure
80, configure PBR on Switch A to forward all TCP packets to the next hop 1.1.2.2.
Command
ip local policy-based-route
policy-name
Command
display ip policy-based-route [ policy policy-name ]
display ip policy-based-route setup
display ip policy-based-route local [ slot slot-number ]
display ip policy-based-route interface interface-type
interface-number [ slot slot-number ]
reset ip policy-based-route statistics [ policy
policy-name ]
315
Remarks
By default, no policy is locally
applied.
Remarks
N/A
N/A
By default, no policy is applied to the
interface.