Disabling Interfaces From Receiving And Sending Ospfv3 Packets; Enabling The Logging Of Neighbor State Changes; Configuring Ospfv3 Network Management - HPE FlexNetwork 5510 HI Series Layer 3 - Ip Routing Configuration Manual

Disabling interfaces from receiving and sending OSPFv3
packets
After an OSPFv3 interface is set to silent, direct routes of the interface can still be advertised in
Intra-Area-Prefix LSAs through other interfaces, but other OSPFv3 packets cannot be advertised.
No neighboring relationship can be established on the interface. This feature can enhance the
adaptability of OSPFv3 networking.
To disable interfaces from receiving and sending OSPFv3 packets:
Step
Enter system view.
1.
Enter OSPFv3 view.
2.
Disable interfaces from
3.
receiving and sending
OSPFv3 packets.

Enabling the logging of neighbor state changes

With this feature enabled, the router delivers logs about neighbor state changes to its information
center, which processes logs according to user-defined output rules (whether to output logs and
where to output). For more information about the information center, see Network Management and
Monitoring Configuration Guide.
To enable the logging of neighbor state changes:
Step
Enter system view.
1.
Enter OSPFv3 view.
2.
Enable the logging of
3.
neighbor state changes.

Configuring OSPFv3 network management

This task involves the following configurations:
•
Bind an OSPFv3 process to MIB so that you can use network management software to manage
the specified OSPFv3 process.
•
Enable SNMP notifications for OSPFv3 to report important events.
•
Configure the SNMP notification output interval and the maximum number of SNMP
notifications that can be output at each interval.
Command
system-view
ospfv3 [ process-id |
vpn-instance
vpn-instance-name ] *
silent-interface { interface-type
interface-number | all }
Command
system-view
ospfv3 [ process-id |
vpn-instance
vpn-instance-name ] *
log-peer-change
360
Remarks
N/A
N/A
By default, the interfaces are able
to receive and send OSPFv3
packets.
This command disables only the
interfaces associated with the
current process. However,
multiple OSPFv3 processes can
disable the same interface from
receiving and sending OSPFv3
packets.
Remarks
N/A
N/A
By default, this feature is enabled.