Maintenance - Datalogic Falcon X3 Quick Reference Manual

5

MAINTENANCE

Rechargeable backup batteries and battery
packs are not initially charged. Therefore
the initial operation to perform is to charge
NOTE
them. See below.
Annual replacement of rechargeable
battery pack avoids possible risks or
abnormalities and ensures maximum
CAUTI
performance.
ON
5.1 CHARGING THE BATTERY PACK
The battery pack autonomy varies according to many factors,
such as the frequency of barcode scanning, RF usage, battery
life, storage, environmental conditions, etc.
NOTE
The battery icon on the Taskbar indicates when the battery pack is low.
It is possible to recharge the battery pack by connecting the power supply directly to the Datalogic
FALCON™.
Alternatively, it is also possible to recharge the battery pack by using a Single Cradle.
Moreover recharging is possible by USB Direct connection with the host computer, but with longer
charging times and in this case it is advised to keep the mobile computer off.
During the charging process the LED positioned at the right side of the display is red constant. Once
the charging process has been completed this LED is green constant (see par. Error! Reference
source not found.).
If the battery pack is removed from the mobile computer, it can be recharged by inserting it into the
rear slot of a Single Cradle.
To safely disable the radio modules
(WiFi/GSM/BT) do not power off/shut off
the terminal, but use the Wireless
WARNING
Communications applet (see par. Error!
Reference source not found.).