Operation - Worx WG545.4 Manual

ASSEMBLY
ASSEMBLING THE BLOWER TUBE
(See Fig. A1 & A2)
Before assembling the Blower Tube(4), be sure
the on/off switch (2) is in ''O'' Off position.
Fit the Blower Tube to the motor housing as
shown in Fig A1. Check if the Blower Tube is
firmly secured.
WARNING! Do not attempt to operate
or disable the On/Off Switch by any
means other than the normal assembly or
removal of the tube.
NOTE: Before disassembling the Blower
Tube, be sure the on/off switch (2) is in ''O''
Off position. Press the Release Button(3) , so
that you can separate the tube. (See Fig. A2)
Do not try to separate the tubes by force or by
using tools.

OPERATION

WARNING! The charger and battery
pack are specially designed to work
together, so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
12
because of an electrical failure and hazard will
occur.
1. BEFORE USING YOUR CORDLESS
BLOWER
Your battery pack is UNCHARGED, you must
charge before use.
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not
use another battery charger.
2. CHARGING YOUR BATTERY PACK
(See Fig. B)
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of
a protective circuit: The machine will stop
running.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
20V Max Lithium multi-purpose sweeper EN
3. CHECKING THE BATTERY CONDITION
(ONLY FOR WG545.4) (See Fig. C)
4. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. D)
Depress the battery release button (6) to
release battery pack from your tool. After
recharging, insert the battery pack into
tool's battery port. A simple push and slight
pressure will be sufficient.
5. STARTING/STOPPING (See Fig. E)
Starting
Move the On/Off switch (2) to the "I" On
position.
Stopping
Move the On/Off switch (2) to the "O" Off
position.
WARNING! The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down.
6. USING THE BLOWER (See Fig. F)
The blower is intended for residential use
only. Use the blower outdoors to move
debris from hard surfaces. This blower is not
designed to clear leaves from large grassy
areas, or move wet, heavy debris.
USER TIPS
- Hold the blow tube approx 7" above the
ground when operating the tool.
Use a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
- After blowing the debris/leaves into a pile, it
is easy to dispose of the pile.
CAUTION!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near bystanders
or pets.
- Use extra care when cleaning debris from
stairs or other tight areas.
- Wear safety goggles or other suitable eye
protection, long pants, and shoes.