General Information; Power Supply - Philips MZ-33 Brochure

XP MZ-33 /37 08-05-2000 16:49 Pagina 9

GENERAL INFORMATION

CAUTION
Use of controls or adjustments or performance
of procedures other than herein may result in
hazardous radiation exposure
Supplied accessories
– 2 speaker boxes
– remote control with batteries
– AM frame antenna
– FM antenna
General maintenance
• Do not expose the set, batteries, CDs or cassettes to
humidity, rain, sand or excessive heat caused by heating
equipment or direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing
alcohol, ammonia, benzene or abrasives as these may
harm the housing.
Environmental information
We have reduced the packing to the minimum and made it
easy to separate into three materials: cardboard (box),
expandable polystyrene (buffer), polyethylene (bags, protec-
tive foam).
Your set consists of materials which can be recycled if dis-
assembled by a specialized company. Please observe the
local regulations regarding the disposal of packing
materials, dead batteries and old equipment.
MZ-3 / 37 page 9

POWER SUPPLY

2 1
Batteries for the remote control
• Open the battery compartment and insert two batteries,
type AA, R06 or UM3 (preferably alkaline) with the
correct polarity as indicated by the + and – symbols
inside the compartment.
Important! Remove the batteries if they are dead or if the
unit is not to be used for a long time.
Batteries contain chemical substances, so they
should be disposed of properly.
Speaker connections
The speaker terminals are click-fit connectors. Use them as
shown below.
– Connect the unmarked wire to the red terminal and the
marked black wire to the black terminal.
• When headphones are inserted into the headphone jack
the speakers are disconnected.
AUX in
6 speakers
LEFT LEFT
– +
RIGHT RIGHT
– +
Power supply
1 Check if the power supply, as shown on the type plate
located on the bottom of the set, corresponds to your
local power supply. If it does not, consult your dealer or
service center.
2 If your set is equipped with a voltage selector on the
bottom of the set, adjust the selector so that it matches
with the local power supply.
3 Connect the power cord to the wall outlet and the set is
now ready for use.
™ The clock display ... : ... flashes.
4 To disconnect the set from the power supply completely,
remove the plug from the wall outlet.
POWER-SAVING AUTOMATIC STANDBY
As a power-saving feature, the unit automatically switches
to standby if:
• 15 minutes after a CD has reached the end and no
control is operated;
• after more than 24 hours no controls are operated.
Safety information
• Place the set on a hard and flat surface so that the
system does not tilt. Make sure there is adequate
ventilation to prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
9