Honda CB UNICORN DAZZLER 2010 Owner's Manual page 72

Installation Notes:
• Reverse the removal procedure.
• Position the wheel between the fork legs
and insert the front axle from the right
side, through the right fork leg and
wheel hub.
• Make sure that the lug (4) on the fork
leg is contacting the lugs on the
speedometer gear box.
• Tighten the front axle nut to the
specified torque.
Front axle nut torque:
59 N·m (6.0 kgf·m , 43 lbf·ft)
• After installing the wheel, apply the
brake several times and then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
64
Improper assembly may lead to loss of
braking capacity.
(4) Lug
¼yx½
Rear Wheel Removal
1. Place the motorcycle on its center
stand.
2. Loosen the rear wheel axle nut (1).
3. Remove the left crankcase cover and
bracket by removing the bolts.
4. Remove the fixing plate and drive
sprocket.