Table of Contents
Advertisement
...6 PROGRAMMING
6.2.1 Operating Page 1
The values displayed in Operating Page 1 are for viewing only and cannot be altered in this page.
Nitrate
<Unit>
or
Mode
xx
•
Millivolts
or
Mode
xx
Control Temp
or
Mode
Slope
xxx
or
Mode
Date
DD:MM:YY
or
Mode
Time
HH:MM:SS
or
Mode
Next AutCal
DD:MM:YY
or
Mode
Last Cal
DD:MM:YY
or
Mode
or
SECURITY CODE -----
12
Measurement Units
The measurement units are displayed, e.g. Ammonia ppm.
Advance to next parameter.
Sensor Output
xmV
The probe output is displayed in millivolts.
Advance to next parameter.
Control Temperature
x
°C
•
The heater block control temperature is displayed in degrees Celsius.
Advance to next parameter.
Slope Check Value
x
%
•
The slope value should be between 80 and 110%. If the value is outside these
limits check the electrode.
Advance to next parameter.
Date
The date is displayed.
Advance to next parameter.
Time
The time is displayed.
Advance to next parameter.
Next Calibration Date
The date when the next automatic calibration is to be carried out is displayed. If the
automatic calibration is disabled, 'OFF' is displayed in place of the date.
Advance to next parameter.
Last Calibration Date
The date of the last automatic or manual calibration is displayed.
Return to top of Operating Page.
or
Advance to Security Page (Section 6.2.3).
Advertisement
Table of Contents
