Advertisement
FSA10-41-DIN
ANTENNA ASSEMBLY
STEP 1:
ASSEMBLE THE DIPOLE TO THE SCREEN AS DEPICTED BELOW ENSURING THE DIPLOLE TO SCREEN
SPACING IS SET CORRECTLY AND THE DRAIN HOLE IS FACING DOWNWARDS.
USING 2 OF THE 4 LARGE CLAMP PLATES AND THE 4 M16 STUD ASSEMBLIES INCLUDED IN THE KIT. TIGHTEN
THE M16 NUTS TO 70Nm (50 lbf.ft). LEAVE APPROXIMATELY 130mm PROTRUDING OUT THE BACK SIDE.
DIPOLE ASSEMBLY
243+/-2MM (9.5")
SET DIPOLE
POSITION
INS-40101-6
M-8648
DRAIN HOLE
M16 THREADED BAR
ASSEMBLY
www. RFIAmericas .com
148-174 MHz
SMALL CLAMP
PLATE
M8x130 BOLT
ASSEMBLY
PAGE 2 OF 4
©RF Industries Pty Ltd 2009
Advertisement
