Start-Up Checklist - AB Quality PowerFlex 700S Quick Start Manual

24 PowerFlex® 700S Drive
Start-Up Check List This section describes how you start-up the PowerFlex 700S.
ATTENTION: Power must be applied to the drive to perform
!
the following start-up procedure. Some of the voltages present are
at incoming line potential. To avoid electric shock hazard or
damage to equipment, only qualified service personnel should
perform the following procedure. Thoroughly read and
understand the procedure before beginning. If an event does not
occur while performing this procedure, Do Not Proceed.
Remove Power including user supplied control voltages. User
supplied voltages may exist even when main AC power is not
applied to then drive. Correct the malfunction before continuing.
Before Applying Power to the Drive
❏ 1. Confirm that motor wires are connected to the correct terminals and are
secure.
❏ 2. Confirm that encoder wires are connected to the correct terminals and
are secure.
❏ 3. Confirm that all control inputs are connected to the correct terminals and
are secure.
❏ 4. Verify that AC line power at the disconnect device is within the rated
value of the drive.
❏ 5. Verify that control power voltage is correct.
The remainder of this procedure requires a HIM (Human Interface Module)
be installed. If an operator interface is not available, remote devices should
be used to start-up the drive.
DRIVE DRIVE
4
ENABLE
SYNCHLINK
PWR (Power)
1
STS (Status)
2
3