AB Quality PowerFlex 700S Quick Start Manual page 18

18 PowerFlex® 700S Drive
(1) The drive's 24V DC power supply supports only on-board digital inputs. Do not use it to power circuits outside of the drive.
(2) Refer to wiring examples of sinking and sourcing outputs.
(1) Refer to Analog Input Settings in the PowerFlex 700S User Manual for necessary dip switch settings.
(2) Analog shields should connect to common at the signal source, if possible. Shields for signals from ungrounded devices, such as analog
tachometers, should connect to an analog shield terminal point at the drive.
Table G TB1 - Row T (Top) Terminals
Terminal Signal
T11 Power Supply 24V DC Return (-)
T10 Power Supply 24V DC (+)
T9 Logic Common
T8 Digital Input #1
Default = Precharge
T7 Enable Input
T6 Digital Output #1
T5 Digital Output #2
T4 Digital Output Return
T3 Thermistor Input
T2 Thermistor Input Return
T1 Thermistor Shield
Table H TB1 - Row B (Bottom) Terminals
Terminal Signal
B11 Analog Input #1 (-)
B10 Analog Input #1 (+)
B9 Analog Input Shield
B8 Analog Input #2 (-)
B7 Analog Input #2 (+)
B6 Analog Output #1 (+)
B5 Analog Output #1 Return (-)
B4 Analog Output Shield
B3 Analog Output #2 (+)
B2 Analog Output #2 Return (-)
B1 Analog Output Shield
Description
Power and common for pre charge
(1)
and enable inputs. Inputs may
(2)
sink or source.
Rating: 100 mA maximum.
For common DC bus drives. Must
be high, for drive to complete the
pre charge cycle.
Load: 20 mA at 24V DC.
Must be high for drive to run.
Load: 20 mA at 24V DC.
24V DC open collector (sinking
logic) output.
Rating: 25 mA maximum.
24V DC open collector (sinking
logic) output.
Rating: 25 mA maximum.
Return for Digital outputs 1 and 2.
Used only in FOC2 mode with
approved motor for temperature
adaptation.
Description
+/-10.0V DC or +/-1.0V DC bipolar,
(1)
differential input. , 13 bit + sign,
20k ohm input impedance
Optional connection point for
(2)
analog input shield.
+/-10.0V DC or +/-1.0V DC bipolar,
(1)
differential input. , 13 bit + sign,
20k ohm input impedance
+/-10.0V DC bipolar, differential
output, 11 bit + sign, 2k ohm
minimum load
Optional connection point for
(2)
analog output shield.
+/-10.0V DC bipolar, differential
output, 11 bit + sign, 2k ohm
minimum load
Optional connection point for
analog shields.
824, 838,
829, 826,
827, 828
824, 825
843, 844,
824
845, 846,
824
485
800, 801,
802, 803,
804, 805
806, 807,
808, 809,
810, 811
814, 815,
816, 817,
812, 818
819, 820,
821, 822,
813, 823