Mylar Bar Assy - CPG Compuprint SP 40 Maintenance Manual

Maintenance Manual
2.12

Mylar Bar Assy

DANGER :
To prevent serious personal injury from electrical shock always turn the printer off and unplug
the power cable before to remove the mylar bar assy.
Mylar bar assy is item 34 of figure 2.15.
To Remove:
1) Remove the top and the main cover assy (see chapter 2.2).
2) Push the green levers in order to rise the upper side of the mechanical assy.
3) Unhook and remove the little spring (item 52 of figure 2.15) on the left side of the printer.
4) Remove the circlip (item 38 of igure 2.15) from the external side of the printer and remove the plastic
lever (item 37 of figure 2.15).
5) Remove other circlip (item 38 of figure 2.15) from the square bar.
6) Moving the square bar toward left extract it from the right frame.
7) Moving the square bar toward right remove it from the left frame and then from the mechanical assy.
To Install:
To install, follow the removal step in reverse order.
Rev. 005
34
SP 40
Chapter 2
Removals