Sd/Usb Operations - JVC KW-NT800HDT Instruction Manual

SD/USB operations

This unit can play the MP3/WMA/AAC/FLAC/MPEG4/MPEG4-AVC H.264/WMV files stored in SD card/USB mass
storage class device.
• All tracks in the SD card/USB device will be played repeatedly until you change the source.
• Make sure all important data has been backed up.
Inserting SD card
1
Open the monitor panel.
2
Insert an SD card.
Push in the SD card until you hear a clicking sound.
3
Close the monitor panel.
Select "SD" as the source.
To eject the SD card
Open the monitor panel, then push in the SD card lightly.
EN_KW-NT800HDT_NT700[J].indb 66 EN_KW-NT800HDT_NT700[J].indb 66
Connecting USB device
You can connect a USB mass storage class device such as
a USB memory, Digital Audio Player, etc. to the unit.
• You cannot connect a computer or portable HDD to
the USB ( ) terminal of the unit.
• When connecting a USB device, refer also to its
instructions.
Select "USB" as the source.
Caution:
• Avoid using the USB device if it might hinder your
safety driving.
• Do not start the car engine if a USB device is
connected.
• Do not pull out and attach the USB device repeatedly
while "File Check" is shown on the screen.
• Disconnect a USB device while playback is paused
or another source is selected.
• Electrostatic shock at connecting a USB device
may cause abnormal playback of the device. In
this case, disconnect the USB device then reset it
and detach the monitor panel (then attach it).
• Do not leave a USB device in the car, expose to
direct sunlight, or high temperature to avoid
deformation or cause damages to the device.
• For more details about USB operations,
☞ page 76.
66
USB cable
(not supplied)
11/21/2011 6:08:09 PM 11/21/2011 6:08:09 PM