Checking The Information Of The Navigation System - JVC KW-NT800HDT Instruction Manual

Checking the information of the navigation system

System Info
1
2
3
Sensor Status
4
5
6
7
w
EN_KW-NT800HDT_NT700[J].indb 43 EN_KW-NT800HDT_NT700[J].indb 43
1 Version of the software
2 Version of the map database
3 Serial number
4 Speed pulse rate
5 GPS antenna connection status
<OK>: Receiving GPS signals (the figure shows the
number of GPS satellites being received).
<NG>: Not receiving GPS signals.
6 Status of the gyroscope
7 Status of calibration *
1
*
<Processing>: The current position cannot be
determined without data from GPS satellites.
<Learning>: The current position can be
determined even when the System cannot receive
data from GPS satellites.
8 Connection status of the illumination control lead
<On>: The illumination signal is detected.
9 Connection status of the parking brake lead
<On>: The parking brake is engaged.
p Connection status of the reverse gear signal lead
<On>: Reverse gear signal is detected.
• If the rear view screen is displayed when shifting
the gear to the reverse (R) position, the reverse
gear signal is detected (<On>).
8
q Information service being received
9
p
(Traffic or Area information; only for KW-NT800HDT)
q
w Resets the calibration data.
1
* The calibration does not function without the
connection of GPS antenna and the speed signal
lead. For the connection, ☞ Installation/Connection
Manual (separate volume).
2
* Driving under various conditions completes the
calibration faster. If <Processing> remains on the
screen for long period, check the connection of the
GPS antenna and the speed signal lead.
43
2
11/21/2011 6:07:58 PM 11/21/2011 6:07:58 PM