Charging The Batteries - Fluke TiR2 User Manual

The Battery tab within the Camera Info window shows the power source,
remaining battery charge level, and battery manufacturer, serial number, and
number of discharge cycles.
To view the Battery tab information:
1. Tap F.
2. Use the mouse controller to position the pointer over Camera Info on the
popup menu and tap E.
3. Position the pointer over the Battery tab and tap E.
4. Tap to return to scan target mode.

Charging the Batteries

Your Camera comes with a battery charger that works with 100 to 240 V AC
input voltage and 50 or 60 Hz input frequency. The charger has a recalibration
feature to maintain correct capacity monitoring. When using battery power, a
battery symbol appears in the far right side of the camera display screen task
bar. The remaining charge capacity is indicated as shown in Table 8-1.
Green
Yellow
Flashing/Solid Red
Use the mouse controller to position the pointer over the battery icon. Press
E to obtain an estimate of the remaining battery charge and camera runtime.
info@Fluke-Direct.com
Table 8-1. Remaining Battery Charge Indicators
Indicator
Fluke-Direct
Camera Care
Charging the Batteries
Battery Power Remaining
25% to 100%
Less than 25%
Approximately 5 minutes until camera
powers off.
.com
8
1.888.475.5235
8-3