Infrared Remote Control - Carrier 42HQM Owner's Manual

42HQM

Infrared remote control

The remote control operates with two 1.5 V non re-chargeable
batteries.
A fading display and reduced control operating range indicate that the
batteries are exhausted.
The batteries have to be replaced when no acoustical receipt signal
is heard or when the signal transmission indicator of the remote
control does not light up.
To insert batteries:
Open sliding cover.
Remove the cover of the battery compartment at the back of the
remote control by sliding it out in the direction of the arrow.
MODE
AUTO
COOL
DRY
HEAT
F
G
C
P
L
WH-K9JE
M
TEMP. FAN
AUTO
QUIET
Hr.ON OFF
TEMP.
• Remove the used batteries and insert new batteries.
The remote control uses two alkaline batteries (1.5 V, LR03x2).
• Wait at least 60 seconds before inserting new batteries.
• Do not use the used batteries.
• The average battery life during normal use is approximately one
year.
The maximum operating range for the remote control is approx. 7 m.
No obstructions such as curtains or plants should be between
control and unit. Direct sun on the unit receiver may interfere with
good signal reception.
The control must be directed toward the unit receiver when
pressing the buttons of the desired functions.
An acoustical acknowledgement sound will indicate that signal has
been received.
A. Display
B. On/Off button
C. Mode selection button
A
D. Decrease/Increase temperature button
E. Fan speed selection button
F. Air flow direction selection button
D
G. Louvre swing selection button
H. Economy mode selection button
B
I. Check button (for service personnel only)
L. Timer ON selection button
E
M. Timer OFF selection button
H
N. Timer memorization button
I
O. Timer cancellation button
O
P. Remote control reset button
N
E N G L I S H
15V +
9Y231
+ 15V
GB - 3