Startup / Operation - BOMANN KS 197 Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Reverse the freezer flap opening

Prior to first use

CAUTION: : : :

CAUTION

After transport, the device should be left standing for 4 hours in order for the oil to be collected in the

compressor. Nonobservance could cause damage to the compressor and hence result in failure of the

device. This would void your warranty claim.

• Clean the interior of the device including all accessory parts located inside. Please consider the

instructions that we have included for you in the chapter on "Cleaning and Maintenance".

Turning on

• Turn on the unit by connecting the device to the power supply.

• Operate the temperature control, which is located in the fridge interior. See also the following sec-

tion "Settings".

Settings

Setting 0 0 0 0 means that the unit is in the off state. Turn the temperature control clockwise, starting from

this setting; the device will turn on automatically. The power levels 1 1 1 1 – 7 7 7 7 regulates the different values

of the internal temperature. When opening the door, the interior lamp will turn on.

Setting 0:

off state

Setting 1:

lowest setting (warmest inside temperature)

Setting 7:

highest setting (coldest inside temperature)

Turning the temperature control clockwise will lower the inside temperature. Please keep in mind that

the temperature changes with the ambient temperature (of the location), with the frequency of door

opening and the amount of food in the device.

During initial operation, turn the temperature control to the highest setting first, until the device has

reached the desired operating temperature. Afterwards it is recommended to turn the control back to a

medium setting; correcting the temperature at a later point would then be easier.

• Open the freezer flap a little. Press the spring of the lower bracket up

slightly with a small screw-driver and remove the bracket incl. freezer

flap.

• Place the blind cap (M) at the opposite side.

• Turn the freezer flap about 180° and press the lower flap bracket into

the appropriated fixture of the freezer flap.

• Lift the freezer flap a little and fix it in the upper door bracket, at the

same time you press the lower door bracket in the square hole. Small

adjustments to the top and bottom will easily the mounting of the flap.