BOMANN KS 197 Instruction Manual page 28

Problem Problem Problem Problem Possible cause Possible cause Possible cause Possible cause
Device cools too Is the temperature control set properly?
much.
The food is too - Is the temperature control set properly?
warm. - Was the device door open for an extend-
ed period?
- Was large quantity of food placed in the
device within the last 24 hours?
- Is the device near a heat source?
Loud noise during Does the device not stand vertical or hori-
operation. zontal?
Water on the - Is the temperature control set properly?
bottom. - Is the water discharge opening blocked?
Light does not - Is the unit not connected to mains pow-
work. er?
- Is the light bulb defect?
The housing The refrigeration cycle takes place in the foaming. The heat exchangers are installed in the
becomes warmly. housing covered. The device cut the interior heat, which must be dissipated through the
housing areas.
Water on the On days of high humidity, condensation might occur on the outer surface of the device. This
outer surface. is no malfunction; you may simply wipe the water off.
NOTE: NOTE: NOTE: NOTE:
If a problem still persists after following the steps above, please contact your trader or an authorized
technician.
Solution Solution Solution Solution
Check the temperature setting.
- Check the temperature setting.
- Open the door only as long as necessary.
- Turn the control panel to a colder setting
temporally.
- Check the installation location (see "Installa-
tion").
Adjust the feet accordingly.
Liquid flow sounds in the cooling circuit are
normal.
- Check the temperature setting.
- Check the discharge opening.
- Insert the plug properly in the contact sock-
et. Check the fuse.
- See the section "Reverse the bulb".
28