Canon Laser Shot LBP5200 Getting Started Manual page 44

3
Remove the 2 screws from the top and bottom sections of
the expansion board slot, and then remove the protective
plate.
IMPORTANT
You will need the screws that you removed to attach the network board.
You will also need the protective plate if you remove the network board.
Store these parts and do not discard them.
4
Insert the network board into the expansion slot.
Hold the metal panel portions of the network board and insert the board so that it
Step is aligned with the guide rails inside the expansion slot.
6
44
IMPORTANT
•
Do not touch any of the components, printed wiring, or connectors on the
network board.
•
Push the network board firmly until the printer connector on the network
board is securely plugged into the connector inside the expansion slot.
5
Attach the top and bottom parts of the network board using
the 2 screws that you removed in Step 3.
6
Plug the LAN cable into the connector in the network board.
Make sure to use a LAN cable that is compatible with the LAN socket on the
network board as appropriate for the network you are using.