Error Messages - Midtronics MDX-500 SERIES Instruction Manual

Battery conductance and electrical system analyzer
Table of Contents

Advertisement

CHAPTER 9:

ERROR MESSAGES

Error Message
Interpretation
BATTERY POWER
Battery being tested has fallen
TOO LOW TO
below 9 volts. Connect to a fully
USE PRINTER.
charged battery to use the printer.
CONNECT TO
FULLY CHARGED
BATTERY 11.50 TO
16.00V
CONNECT TO 12V
Tester is not connected to the
BATTERY
battery.
LOW INTERNAL
Internal AA batteries are low
AA BATTERIES.
and need to be replaced. See
REPLACE AA
"Maintenance & Troubleshooting"
BATTERIES SOON!
section.
NON 12 VOLT
System being tested is not 12-volts.
SYSTEM DETECTED
PRINTER DOOR
Door covering printer paper is not
OPEN. CLOSE
secure.
DOOR AND TRY TO
PRINT AGAIN
PRINTER OUT OF
Printer is out of thermal paper.
PAPER REPLACE
Replace with new roll. See
WITH THERMAL
"Maintenance & Troubleshooting"
PRINTER PAPER.
section.
2.5 IN. DIA. MAX.
2.23 IN. WIDE
MAX.
Midtronics B.V.
Hoofdveste 6
3992 DG HOUTEN
12
www.midtronics.com

Advertisement

Table of Contents
loading

Table of Contents