Table of Contents
Advertisement
Care and Maintenance
Cleaning Water Reservoir
It is important that you clean out and refill the
Water Reservoir at both the "CW" and "RC"
messages.
1. Remove the Lid Stopper from the back of Lid.
2. Let the Lid gently open to its farthest position.
3. Pull off the Turntable from the Main Motor
4. Locate the removable Catch Tray. Pull up on
5. Locate and pull down on the Back Panel Door,
6. Remove the feed tubing from the reservoir, it's
7. Pull the Water Reservoir out of the machine.
8. Remove the filter from the reservoir and clean
9. Remove the reservoir clips and pull the top
10. Pour out and dispose of the water from the
11. Put the reservoir back together and Re-install
12. Re-install the Catch Tray.
13. Towards the back right hand corner of the
14. Watch the visual water display on the front
shaft.
the outer edges of the tray and remove from
the machine.
on the rear of the machine, to expose the
Water Reservoir.
in the rear of the machine, located on the right
hand side of the reservoir.
it under warm water.
part of the reservoir from the bottom.
reservoir. Wash the inside of the reservoir with
warm water until clean.
the clips. Insert the reservoir into the machine
and reconnect the water feed tube.
Catch Tray is a drain that connects to the water
reservoir. Pour about 750ml of water into this
area.
of the machine as you fill the reservoir with
water.
(Do not fill past the 'MAX' fill line)
15. Re-install the Turntable.
16. Re-install the Lid Stopper.
17. If the Water Reservoir was cleaned due to
the "CW" message, press the "Regular"
and then the "Heavy" buttons on the User
Keypad, to inform the machine that the
pads were replaced.
18. If the Water Reservoir was cleaned out due
to the "RC" message, no further action is
required, unless other consumables need to
be replaced.
Replacing Center Hubs
The Center Hub must be replaced at the same
time that all the other consumables are being
replaced due to the "RC" message.
1. Make sure the Lid is in the "Open" position.
2. Locate the Center Hub.
3. Pull the used Center Hub off of the Hex
shaped post with your Index Finger and
Thumb.
4. Take the new Center Hub and line up the
Hex shaped opening on the hub with the
Hex shaped post.
5. Push the Center Hub onto the post.
6. Spin the Center Hub by hand to make sure
the Hub is centered. If needed, make the
proper adjustment.
Page 7
Advertisement
Table of Contents
