Powering Up The Machine - TDR VMI QUICKSAND User Manual

Initial Setup
Understanding the Consumables
You will receive starter consumables in the box for 50 minutes:
2 x Foam Pads
2 x Sanding Pads
1 x Center Hub
2 x Jet Nozzle Extender
1 x Credit Chip:
A starter Credit Chip of 50 minutes is
included with your QuickSand. This will
show as 50% on your supply display.
Installing the Credit Chip
Take the Credit Chip provided with your machine, and install it into
the Chip Port.
The Quicksand unit will recognize this chip once the machine is
powered on.
This chip only applies 50% credit; a new 100 minute chip will apply
100% credit.

Powering up the Machine

Insert the power Cable into the power inlet on the back of the
machine and plug into the wall socket.
Power up using the on/off switch found on the back of the machine
(After a couple of seconds, the Lid will automatically open.)
Leave the Lid in the open position.
Filling the Reservoir with water
Remove the Lid Stopper.
Locate the Turntable Assembly
and remove from the machine
by pulling up.
(Please turn over for the rest
of this instruction)
Page 2