Care And Maintenance; How To Clean The Filter - TDR VMI QUICKSAND User Manual

Care and Maintenance

Replacing Sanding Pads
The machine will notify the Operator to
replace the Sanding Pads by displaying the
"CP" message after 25 minutes of machine
operation.
1. Remove the Lid Stopper from back of Lid.
2. Make sure the Lid is in the "Open" position.
3. Pull the Sanding Pads away from the
Foam Pads, until the pads are completely
detached.
4. Take a new Sanding Pad and line it up
with the Foam Pad. It is essential that the
Buffing Pad CENTERED on the Foam Pad.
Make sure that both Sanding Pads are
seated fully on to the Foam Pads.
5. Re-install the Lid Stopper.
6. Press the "Regular" and then the "Heavy"
buttons on the User Keypad to clear screen.

How to clean the Filter

The filter for the water reservoir must be
cleaned at the same time as replacing the
Sanding Pads, when the machine gives off the
"CP" message. This will occur after 25 minutes
of machine operation.
1. Remove the Lid Stopper from the back of
the Lid.
2. Let the Lid gently open to its farthest
position.
3. Pull off the Turntable from the Main Motor
shaft.
4. Locate the removable Catch Tray. Pull up
on the outer edges of the tray and remove
from the machine.
SAVE
5. Locate the Water Reservoir and the opening
for the filter. Pull the filter out of the
reservoir.
6. Rinse the filter under warm water until all
of the plastic remnants are washed away.
7. Re-install the filter and catch tray.
8. Check the level of water inside of the
reservoir by looking at the water display on
the front of the machine. If the water level
is low, please replenish the water. (Do not
fill past the 'MAX' fill line)
9. Re-install the Turntable onto the shaft of
the Main Motor.
10. Re-install the Lid Stopper.
Replacing Foam Pads
The machine will notify the Operator to replace
the Buffing Pads by displaying the "RC"
message.
1. Make sure the Lid is in the "Open" position.
2. Locate the Foam Pads.
3. Pull the Foam Pad away from the Foam
Pad Holder, until the pad is completely
detached.
4. Repeat step #3 for the second Foam Pad.
5. Take your new Foam Pad and line it up with
the Foam Pad Holder. It is essential that the
Foam Pad is CENTERED on the Foam Pad
Holder. Make sure that the new Foam Pad
is fully seated on the Foam Pad Holder by
pressing gently on the entire surface of the
pad.
6. Repeat step #5 for the second Foam Pad.
7. You must also at this stage, install a new
set of Sanding Pads.
Page 6