CDI CD42-T1A User Manual page 4

QUICK START
CD42 T SERIES
1. PREPARE TRANSMITTER CONT.
T3 MODEL:
Remove Ba eries
Confi gure Pulse re Pu u lse
Pa ern
T4 MODEL: All T4 model transmi ers are programmed at the factory.
(There are no dip switches)
T0, T1, T1A/T1AHP/T1AVHP, T2
T0: Load Carousel with six (6)
N-Cell alkaline ba eries
T1, T1A/T1AHP/T1AVHP, T2: Load Carousel
with six (6) AA-Cell alkaline ba eries
T3 & T4 MODELS:
T3: Load single CR-123 ba ery, posi ve (+) end fi rst.
T4: Load two (2) CR-123 ba eries, nega ve (-) end fi rst,
posi ve (+) end UP.
NOTE: it is good prac ce to always install
new ba eries prior to deployment.
ALL MODELS: Replace End Cap
NOTE: Unless transmi er is fi ed with CD42-SWX
pressure-ac va on switch or factory-confi gured for DELAY ON
opera on, it is ac ve when cap is replaced.
22 Hz ELECTROMAGNETIC TRANSMITTER USER GUIDE
TER CONT.
MODELS:
ery, posi ve (+) end fi rst.
eri i es nega ve ( ) end first
Page 4 of 52
Standard
Skip-One